Linear Position Sensor LP 100-H

The sensor is designed to measure linear movement, e.g. the stabilizer bar movement. The electronic is designed with a stainless steel magnetic shaft with Hall element. The Hall element is disposed between two magnets in association with a movable specially formed ferromagnetic part. This is used to control flux in the sensor in order to produce a linearly varying output voltage dependent on the position.

The main benefit of this sensor is its contactless Hall effect technology and its robust design for motorsport applications.

Features

  • Application: 0 to 100 mm
  • Housing: Aluminum
  • Weight w/o wire: 35 g
  • Technology: Hall contactless
  • Output signal: 0.025 to 4.975 V

Application

Application

Up to 100 mm

Operating temperature range

-40 to 125°C

Max. vibration

Vibration Profile 1 (see www.bosch-motorsport.com)

Technical Specifications

Mechanical Data

Weight

35 g

Protection class

IP68 & IP69K

Mounting

2 x M4

Shaft bearing life

25 million cycles

Housing

Aluminum sulphur anodised

Shaft

Stainless steel 303

Electrical Data

Power supply US

5 V ± 0.25 V

Current IS, during power on settlement

< 100 mA

Current IS, normal operation

< 45 mA

Resolution

0.025 % of measurement range

Characteristic

Temperature coefficient

< ± 0.003 % FS/°C

Sensitivity tolerance

< ± 2.5 % FS

Non-Linearity

< ± 0.5 % FS

Connectors and Wires

Connector

ASU 6-03-03 PA-HE

Connector loom ASU 0-03-03SA

F 02U 000 194-01

Pin 1

Power 5 V

Pin 2

Ground

Pin 3

Signal 0.05 to 4.95 V

Sleeve

FDR-25

Wire size

AWG 26

Wire length L

15 to 50 cm

Various motorsport and automotive connectors on request.

Please specify the requested wire length with your order.

Installation Notes

The sensor can be connected directly to most control units.

The sensor is designed with contactless Hall effect technology.

Each mounting orientation is possible.

The sensor is also ferromagnetic sensitive. Please make sure the mounting material is not ferromagnetism. This can lead to inaccurate measurement.

Safety Note

The sensor is not intended to be used for safety related applications without appropriate measures for signal validation in the application system.

Ordering Information

Linear Position Sensor LP 100-H

Order number: F 02U V02 061-01

Downloads

Documents